This is a much less efficient use of material and as a result lifting beams are in general heavier and more costly than spreader bars.
Spreader beam vs lifting beam.
About spreader beams and lifting beams a lifting beam has a centre lifting lug at the top that connects to a crane hook.
A basic lifting beam will have a bottom lug at each end to connect to slings or hook directly into the load in some circumstances.
Arrangement of a spreader bar spreader beam vs lifting beam.
Lifting beams on the other hand consist of a long beam that converts the lifting load into a bending moment through the beam.
Heavy or unbalanced lifts sometimes require more stability or capacity than a sling hitch can give.
A spreader beam utilises a two legged top sling.
Find the load capacity minimum and maximum spread and headroom that fits your application.
Problems occur when a spreader beam is treated as if it were a lifting beam.
A spreader beam is designed to take primarily compressive loads as can be seen in the figure above.
Shop grainger today for spreader beams and other lifting equipment that can help you lift large items safely.
Lifting beams and spreader bars are some of the most common types of lifting devices however the difference is often misunderstood.
When headroom is limited use a lifting beam.
Lifting beams have a single centred lifting point on the top side of the beam to connect to a crane hoist or other lifting mechanism.
Beams increase the safety and efficiency.
If we resolve the forces on the whole beam we get the force diagram as above.
Spreader beams have lugs at either end which attach to the crane s sling and two lugs on their underside that attach to the load.
Lifting beam vs spreader beam a sling alone isn t always enough to safely move a load.
The way their lugs are orientated means the load taken by the spreader beam is mainly compressive so they can carry a great deal of weight compared to their size.
At the outset it is important to clarify the difference between a spreader and a lifting beam.
The beam was designed to deal with compression not bending.
This is when riggers turn to below the hook lifting devices like lifting beams and spreader beams.
The main difference between a lifting beam and a spreader bar is the design which dictates the way the force is transmitted during the lift.
It is a simple design with one lifting eye on the beam s topside for connecting the crane.
As a result a spreader beam will likely fail if it is not used correctly remember it is 3 to 4 times smaller than a lifting beam.
