Flush the toilet and then remove the flapper valve.
Toilet water shut off valve leaking australia.
It is located inside the toilet tank at the bottom.
Wrap cloth or masking tape on the plier s jaws to protect the nut s finish.
If the main valve is the one that s dripping you ll need to turn off the street side valve before replacing it.
Do not remove the valve just tighten the packing nut.
The chain hook must be removed and a new flapper set into its place.
Water leak shut off valve fixing for a leaky toilet water shut off valve the easiest solution is to tighten the package nut 1 4 turn with a wrench.
Wrap the slip joint pliers jaws in masking tape to protect your shut off valve from any scratches caused by the sharp edges.
Shut off water supply to the house at the main.
Tighten the packing nut on the toilet shutoff valve one eighth turn clockwise to try to seal a leak around the nut.
If the street side valve needs replacement as well you ll have to call your water utility company to shut off the water supply at the curb.
Next shut off the main water supply to the toilet and detach and drain the pipes using a wrench or pliers.
Water will stop flowing into the tank.
Place a bucket or a thick towel on the floor under the leaky valve just in case some residual water leaks out during work.
Step 3 remove the nut.
To fix a leaking flapper valve turn the water shut off valve on the intake pipe just below the toilet tank to the closed position.
Then flush the toilet to empty the tank.
When you re ready to get started shut off the water.
Place the small container underneath the valve in case some water leaks into it while you do the repairs.
Disassemble the shutoff valve.
If you still can t stop the dripping you ll have to turn off the main valve and replace the drippy one completely.
Flush all the toilets in the home.
Step 3 remove the screw in the center of the shutoff valve handle using a screwdriver.
The small plastic tub will catch the water from the pipes to avoid spillage.
How to replace a toilet seal in 16 steps.
Hopefully this is enough to compress the rubber gasket so that it is sealed on the valve stem to prevent water leaks.
Let water drain from open faucets.
You can do this by turning the valve by the toilet base clockwise.
Turn on all the faucets and flush all the toilets associated with the main shutoff valve to empty the pipes of water.
Open all the cold water faucets start with the highest faucet 2nd or 3rd floor and work to your lowest faucet first or basement floor.
